SilverStone ML01S-R Guide d'installation télécharger pdf (Page 5)

10 11

Installation Guide

Rubber padding

Rubber padding placement

Take out the rubber padding and stick it right behind the optical drive buttons on the front panel.

Take out the three special hard-drive screws provided

in accessory packet (refer to photo), tighten those screws

into Hard Disk Drive as pictured.

Place the Hard Disk Drive into the case according

to the picture.

Take out one piece of M3*6 screw, use a screw driver to secure Hard Disk Drive into place as pictured.

1 2 3 4 5 6 7 8

Pas de commentaire

SilverStone ML01S-R Guide d'installation Page 5