SilverStone ML01S-R Guide d'installation télécharger pdf (Page 4)

Installation Guide

Take out two pieces of M3*4 screws, and secure the external 3.5"device as pictured.

Take out the external 3.5"drive bay cover from the front panel.

From the accessory packet, take out two pieces of M3*4

screws and screw the optical drive into place as pictured.

If optical drive cover on the front panel touches the optical

drive and prevents the front panel from installing properly,

use pre-drilled hole B to secure the optical drive instead,

then use of a rubber filler is then required as pictured.

Take out a thumb screw from the accessory packet

and secure the optical drive into place as pictured.

Plastic

thumb screw

1 2 3 4 5 6 7 8

Pas de commentaire

SilverStone ML01S-R Guide d'installation Page 4